Welcome to SGM

0661 240 1784
0661 240 0025

2nd Floor,A1,Commercial Estate
Civil Township,Rourkela,Odisha

shreeganeshmeta@gmail.com
info@sgml.in

Induction furnace

  • Home
  • Induction furnace

Plant Induction furnace

Steps involved in a furnace can be summarized as follows

Charging

The Charge is set up as per the evaluations proposed science for the focused on grade, Sponge iron and different fixings are charged in heater in a nearby imperative proportion.

Melting

Dissolving is practiced by infusing vitality into the charged materials as electrical vitality. Carbon infused inside the heater responds with oxygen-delivering CO, which rises through the shower making frothy slag. The overabundance CO responds with oxygen, changing over to CO2, again producing heat. Oxygen will respond with a few parts present in the shower including silicon; manganese; phosphorus and sulfur. The oxides in this manner shaped will wind up in the slag. In curve heater charged materials get softened at about 1800°C. When an adequate charge has been dissolved and enough space has been made, the subsequent charge can be taken and the procedure is rehashed. When the last charge has been liquefied and is reached at the liquefy stage, Temperature estimation is taken and the example is drawn for deciding the measure of oxygen to be blown during refining.

De-slagging

De-slagging is the procedure by which the slag layer over the steel is expelled from the heater. This procedure is significant for expelling contaminations from the liquid material. The heater is tilted towards the slag entryway for slag evacuation. Phosphorus is moved to the slag, during the beginning period of the warming while the temperature is moderately low. The primary de-slagging (toward the start of refining) expels the generous bit of the phosphorous (as P2O5) subsequently forestalling phosphorous inversion to the metal. Ordinarily, during the refining state, the heater might be de-slagged a few times.

Tapping

Subsequent to arriving at the necessary temperature and arrangement, the tap gap is opened and metal is taken advantage of the scoop and sent to a nonstop throwing unit for the throwing of billets, during the tapping procedure mass compounds depend on the shower investigation for the ideal steel grade. De-oxides might be added to the steel to control the oxygen content, preceding further handling. This is normally alluded to as the executing of steel. This is finished by including adle ium or silicon as ferrosilicon or silicon manganese. The heater is tilted towards the slag entryway for slag evacuation. Phosphorus is moved to the slag, during the beginning period of the warming while the temperature is moderately low. The primary de-slagging (toward the start of refining) expels the generous bit of the phosphorous (as P2O5) subsequently forestalling phosphorous inversion to the metal. Ordinarily, during the refining state, the heater might be de-slagged a few times.

    dri-unit

Shree Ganesh Metaliks